![]() ![]() ThisĬan be overcome by simply making sure that all your devices are on the Note that many access points only support subnet masks ofĢ55.255.255.0 instead of the normal Art-Net subnet mask 255.0.0.0. The access point should be in the same IP address range as the MagicQįor example, if the console is set to IP address 2.0.0.5 then theĪccess point should have an IP address on the 2.0.0.x network – e.g.Ģ.0.0.1. In order for the wireless access point to work correctly with MagicQ, Manual for your access point to determine how to configure it. ![]() DHCP may be enabled orĭisabled by default depending on the type of access point. the access point will attempt to give out IPĪddresses to other computers on the network. Most acess points haveĭHCP support - i.e. Username and password - you will need to consult the instruction manualĪccess points usually default to a standard IP addess such asġ92.168.1.1 and subnet mask of 255.255.255.0. Most access points have an inbuilt web server that enables configurationįrom a PC or Mac using a web browser. In order to use a wireless access point with MagicQ you must configure theĪccess point with an SSID, password, IP address and subnet mask. You can specify a particular IP address to connect to by entering the IP address in the command line before pressing REMOTE CONTROL or through the "Specify IP" option in the list of consoles. System – for example, this can be MagicQ PC running on a wireless Restrictions on the MagicQ system that you use to control the remote ![]() MagicQ PC Wing or MagicQ USB interface attached. Wish to control) is a MagicQ console, or it is a MagicQ PC system with a This function is only enabled when the target system (i.e. Having two operators will cause confusion! We recommend that you only use one interface at a time – When a remote system is under remote control it is still possible toĬontrol the system locally – the normal system interface is still fully The status line will change back to be the normal Alternatively press QUIT or CTRL CLOSE on theĬontrolling system. To end remote control of another system press CTRL 1 on the keyboard of When MagicQ is remoteĬontrolling another console it indicates "REM" at the start of this Name in the Status Display (above PB1 to PB5). You can tell which system you are controlling by looking at the system If for any reason it cannot connect to the console you can abort the remote control by pressing the backspace ←- key, or by pressing CTRL CLOSE. Network and you can choose which one you wish to control. Of all the other MagicQ consoles / MagicQ PC systems it can find on the MagicQ press the Remote Control soft button. The remote control function can be accessed from MagicQ in Setup, View System, View Monitors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |